In intermediate mode, it’s also dependent on your action test. As you know from simplified mode, the progress you make in the meter is dependent on how close you are to the target. Seducing the target also has an action test. A red result will still cause the Spy to say the code phrase, but then will visually and audibly cough. A green result will make the Spy say the code phrase immediately and with no talking animation. A white result is the same as it is in simplified mode: the Spy will say “Banana Bread” after a short delay and in the middle of a talking animation. Contact Double Agent ChangesĬontacting the Double Agent will also require an action test. A red result will cause a slower swapping animation that the Sniper is more likely to see. The animation for an AI swap is slightly faster, so a keen Sniper may be able to tell the difference. Instead, it will call an AI over to swap the statue for you. A green result will not immediately swap the statue. A white result will do the swap just as it does in simplified mode. In experienced mode, swapping statues has an action test. What each result means for the different spy actions will be explained below.

Note, if nothing is pressed by the time the line reaches the end, the action test will result in a white result. A red action test will reward no subtlety, and depending on the action may cause a more obvious Spy behavior. Stopping the bar within the white area will cause a normal action, this has been the default for you thus far.

If you successfully perform a green action test (by stopping the line within the small green area) the reward is a more subtle Spy Action. If red and green are hard to distinguish for you, you can enable the “Use Alternate Test Bar Colors” toggle in the Accessibility section of the Settings menu. The ultimate goal is to stop the line within the small green area.

The bar is split into three regions: a wide red area, a smaller white area, and a tiny green area. Pressing/clicking again will stop the line. When you initiate a Spy action, a bar will appear and a line will go across the bar. This is called an action test and it will determine how subtle your Spy action is. In Intermediate Mode, there is an added component to some of these actions. Up until now, every Spy action you’ve performed (“Swap Statue”, “Check Watch to Add Time” etc.) has automatically succeeded.

Spyparty microfilm